1. Consider the ring measurement for every individual you're creating a ring for. Achieve this using a bit of string, looping this close to every person’s ring finger as well as tagging the actual locations in which the string all comes together. Measure the actual string lengths with a ruler and write down the measurement for each person. Figure out the actual thickness for every ring, too. Rings could be produced in widths between 1/8 in. and 5/8 in.
2. Consider the sheet metal you're producing your own wedding rings from. Numerous wedding rings tend to be carried out within silver or gold, although many people choose white gold or even platinum. On the sheet metal, make use of a pen in order to draw rectangles within the length and width measurements you took from each person. Reduce every rectangular shape in the metal, while using jeweler's saw. At this time, in order to include ornamental cutout styles for your rings, pull all of them on to the actual rectangles as well as reduce all of them away. You are able to cut all of them very easily through punching a hole through the rectangle with a drill bit, after that unscrewing one part of the saw blade and pushing this through the hole. Reattach the blade and cut.
3.File and sand the edges of the rectangles flat and smooth, and also file and sand the inner edges of any cutout shapes you made in Step 2. Make sure that the design looks the way you want it to. In your soldering area, screw all of the rectangles into the clamps and lightly heat them with the torch. Using the tongs, and never touching the hot metal with your hands, remove the rectangles from the clamps and put them into the pickle pot for a minute.
4.Bend each rectangle into a loop, until the ends meet tightly together. If it is too difficult to bend the rectangles with your hands, put them onto the ring mandrel and bang them into round shapes with the wooden mallet. Paint a little flux on the short ends, where they meet, and place small pieces of solder along this line.
